Module, Active Damping Control (ADCM): Installation

Courtesy of CHRYSLER GROUP, LLC

1. Place the Active Damping Control Module (ADCM) (3) into position and install the three ADCM retaining screws (2). Tighten to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
2. Install the retaining screws (2) and tighten to 9 N.m (80 in. lbs.).
3. Connect the wire harness connectors (1) to the ADCM (3). Install the inner left rear wheel well carpet. Refer to CARPET, INSTALLATION .
4. Connect the negative battery cable.
5. Perform the ADCM Verification Test.