Module, Body Control (BCM): Installation

Courtesy of CHRYSLER GROUP, LLC

Slide the BCM into position so that the top two mounting tabs (1) on the BCM are properly aligned to the mounting weld studs and the lower mounting tabs slide into their respective mounting weld studs.
Install the lower fastener (3), and tighten the securely.
Tighten the upper fasteners securely.
Connect the electrical connectors to the BCM receptacles.
Install the glove box assembly (1). Refer to GLOVE BOX, INSTRUMENT PANEL, INSTALLATION .
Connect the negative battery cable.

NOTE:

Program the BCM in accordance with the module replacement and programming guide. Refer to RF-HUB, BCM, PCM, FOBIK REPLACEMENT AND PROGRAMMING ORDER GUIDE .