Diagnostic Test
- CHECK FOR AN ACTIVE DTC NOTE:
This DTC must be active for the results of this test to be valid.
- Perform any Service Bulletins that may apply.
- Turn the ignition on.
- With the scan tool, read DTCs and record on the repair order.
- Cycle the ignition from off to on.
- With the scan tool, read TPM DTCs.
Is the DTC active?
Yes
- Go To 2
No
- Test complete. The condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
- CHECK BODY CONTROL MODULE (BCM) CAN BUS DTCS ARE PRESENT
- With the scan tool, read the BCM DTCs.
Are there any BCM CAN BUS DTCs present?
Yes
- Perform the appropriate diagnostic procedures. Refer to DIAGNOSTIC CODE INDEX .
No
- Go To 3
- With the scan tool, read the BCM DTCs.
- CHECK OTHER MODULES FOR CAN BUS DTCS
- With the scan tool, read the DTCs.
Are there any CAN BUS DTCs present?
Yes
- Using the schematics as a guide, check the Body Control Module (BCM) pins, terminals, and connectors for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. If no problems are found, replace the Body Control Module (BCM) in accordance with the Service Information. Refer to MODULE, BODY CONTROL (BCM), REMOVAL .
No
- Using the schematics as a guide, check the Tire Pressure Monitoring (TPM) Module pins, terminals, and connectors for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. If no problems are found, replace the Tire Pressure Monitoring (TPM) Module in accordance with the Service Information. Refer to MODULE, TIRE PRESSURE MONITORING (TPM), REMOVAL .
- Perform the TPM Verification Test. Refer to TPM VERIFICATION .
- With the scan tool, read the DTCs.