TCM Adaptation - 8HP45

WARNING: This page is about a different car, the 2012 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

The 8HP45 transmission continuously self calibrates and learns shift points and clutch apply times. It is necessary to perform a drive cycle to provide the proper baseline transmission adaptation. The adaptation procedure should be performed if any of the following procedures are performed:

Transmission Assembly Replacement
Transmission Control Module Assembly (TCMA) Replacement
Internal Transmission repairs.
Torque Converter Replacement.

With the scan tool, clear any DTCs that may be set.
Drive the vehicle until the vehicle temperature is greater than 30°C (86°F).
After the vehicle has reached normal operating temperature, and with the scan tool, monitor actual gear state. Drive the vehicle normally with the accelerator pedal between 10% and 20% until 7th gear has been achieved, approximately 76 km/h (47 mph). After 7th gear has been achieved, coast down to 30 mph with no application of the brake or accelerator to allow a 6-5 shift. Brake the vehicle to a stop. Repeat this procedure 5 times.