Module And Bracket
WARNING: This page is about a different car, the 2017 Dodge Charger. However, it is still accessible from the selected car via links, so may be relevant.
- Check to be certain that the two rivet nuts are properly installed and in good condition in front bumper support bar.
- Position the mounting bracket to the bumper support bar.
- Install and tighten the two screws (2) that secure the mounting bracket (1) to the support bar. Tighten the screws to the proper. Refer to TECHNICAL SPECIFICATIONS .
- Install the energy absorber.
- Connect the wiring harness connector (1) to the ACC sensor module.
- Install the front fascia. Refer to FASCIA, FRONT, INSTALLATION .
- Connect the negative battery cable.
- Perform the ACC module alignment procedure. Refer to MODULE, ADAPTIVE CRUISE CONTROL (ACCM), MODULE PROGRAMMING .