Module, Memory: Installation
WARNING: This page is about a different car, the 2017 Dodge Charger. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Depending on how equipped, more memory seat module electrical connectors may be present than shown in the illustration.
- Position the Memory Seat Module (MSM) (2) to the bracket (4) and connect all electrical connectors to the rear of the MSM.CAUTION:
Properly align the Memory Seat Module (MSM) retaining tabs to the bracket, prior to engagement. Failure to follow these instructions may result damage to the MSM retaining tabs.
- Install the MSM into the bracket and engage the two rear MSM retaining tabs to the bracket.
- Engage the two front MSM retaining tabs (3 and 5) to the bracket by carefully pulling down on the front of the MSM.
- Connect all the electrical connectors (1) to the front of the MSM.
- Install the driver seat Refer to SEAT, FRONT, INSTALLATION .
- Reconnect the negative battery cable.
- Perform the Power Seat System Verification test. Refer to POWER SEAT SYSTEM VERIFICATION TEST .
- Verify proper memory seat system operation.