Module, Tire Pressure Monitoring (TPM): Installation

WARNING: This page is about a different car, the 2017 Dodge Charger. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of CHRYSLER GROUP, LLC

Position the Tire Pressure Monitoring (TPM) module in the RH wheel well.
Install the front TPM module nuts (2), then install the TPM module nuts (3) at the body flange.
Connect the TPM module electrical connector (1).
Install RH rear splash shield. Refer to SHIELD, SPLASH, REAR WHEELHOUSE, INSTALLATION .
Carry out one of the following to update the system for the new sensor ID:
1. Using the TPM-RKE Analyzer 9936 with the Scan Tool, program the TPM Module with the new tire pressure sensor ID. This is part of the TPM Diagnostic Verification Test. Refer to STANDARD PROCEDURE .
2. The vehicle should remain stationary for at least 20 minutes. Drive the vehicle for a minimum of 20 minutes while maintaining a continuous speed above 24 km/h (15 mph). During this time, the system will recognize and add the new sensor ID.
  This is part of the TPM Diagnostic Verification Test. Refer to TPM VERIFICATION .