Installation - Nag1
WARNING: This page is about a different car, the 2017 Dodge Charger. However, it is still accessible from the selected car via links, so may be relevant.
- Place the TCM (1) in position on the instrument panel support beam.
- Install the screws (2) to hold the TCM (1) to the instrument panel support beam.
- Push the wire connectors onto the TCM until the lock tabs click into position.
- Install the driver side knee blocker.
- Install the driver side under instrument panel silencer pad and courtesy lamp.
- Connect the battery negative cable.
- Perform TCM programming. Refer to MODULE, TRANSMISSION CONTROL (TCM), MODULE PROGRAMMING .
- Perform the transmission verification test. Refer to the appropriate diagnostic & testing article. .