LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2017 >> Challenger SXT Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 2050 (Electronic Control Modules (Service Information)) >> Module, Integrated Center Stack (ICSM) >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Module, Integrated Center Stack (ICSM): Removal

WARNING: This page is about a different car, the 2020 Chrysler 300 and 2019 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the transmission shifter. Refer to SHIFTER, TRANSMISSION, REMOVAL .
    GC0170863Courtesy of CHRYSLER GROUP, LLC
  3. Remove the fasteners (2) securing the storage bin (1).
  4. Pull the storage bin out to release the retaining clips and position the bin to the side. The storage bin interconnects with the Integrated Center Stack (ICS). The ICS cannot be removed with the storage bin in the installed position.
  5. Using a trim stick or equivalent, pop the ICS loose from the dash.
    GC0170795Courtesy of CHRYSLER GROUP, LLC
  6. Disconnect the wiring harness connector (1) from the back of the ICS.
    GC0170770Courtesy of CHRYSLER GROUP, LLC
  7. Remove the fasteners (1) securing the ICS to the trim panel.
scientia non olet · About LEMON Manuals