LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2017 >> Challenger SXT >> Repair and Diagnosis >> External Pages >> Different car >> Section 1311 (Electronic Control Modules (Service Information)) >> Module, Occupant Restraint >> Removal And Installation >> Removal And Installation >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal And Installation: Removal

WARNING: This page is about a different car, the 2016 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

To avoid serious or fatal injury on vehicles equipped with side curtain airbags, disable the Supplemental Restraint System (SRS) before attempting any Occupant Restraint Controller (ORC) diagnosis or service. The ORC may contain a rollover sensor, which enables the system to deploy the side SRS components in the event of a vehicle rollover event. If an ORC containing a rollover sensor is accidentally rolled during service while still connected to battery power, the side SRS components will deploy. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.

WARNING:

To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbags, airbag curtains, knee blocker, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect the IBS/negative battery cable assembly from the negative battery post, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.

WARNING:

To avoid serious or fatal injury, never strike or drop the Occupant Restraint Controller (ORC), as it can damage the impact sensor or affect its calibration. The ORC contains the impact sensor, which enables the system to deploy the SRS components. If an ORC is accidentally dropped during service, the module must be scrapped and replaced with a new unit. Failure to observe this warning could result in accidental, incomplete, or improper SRS component deployment.

Fig 1: Front Side Panel & Clips
GC0169447Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable. Wait two minutes for the system capacitor to discharge before further service.
  2. Remove the front side panel (1b) from the right side of the center floor console on the floor panel center tunnel. Refer to CONSOLE, FLOOR, REMOVAL AND INSTALLATION .
    Fig 2: Occupant Restraint Controller, Connector & Nuts
    GC0169540Courtesy of CHRYSLER GROUP, LLC
  3. Disconnect the wire harness connectors (1) from the rearward-facing end of the ORC (2b). To disconnect the wire harness connector from the ORC, depress the release tab and lift the lever arm on the connector.
  4. Remove the three nuts (2a) that secure the ORC to the weld studs on the floor panel center tunnel.
  5. Lift the ORC off of the weld studs and remove it from the vehicle.