Module, Drivetrain Control (DTCM): Installation

Courtesy of CHRYSLER GROUP, LLC

1. Slide the Drivetrain Control Module (DTCM) (3) on the mounting stud (6) and over mounting stud (5).
2. Install the mounting nuts (2 and 4). Tighten the nuts to 16 N.m (12 ft. lbs.).
3. Position the foot rest over the drivers floor. Connect wire harness connector.

   Courtesy of CHRYSLER GROUP, LLC

4. Slide foot rest (2) forward to engage top tab and let rear rest on floor, install nut (1) and tighten securely.
5. Position the driver side carpet in place.
6. Install the driver side floor cowl trim. Refer to PANEL, COWL TRIM, INSTALLATION .