Module, Integrated Center Stack (ICSM): Operation

The Integrated Center Stack (ICS) Module allows manual control of the multiple vehicle systems. The ICS communicates on the Controller Area Network - Interior High Speed (CAN-IHS) data bus and controls all connected vehicle systems via CAN messages.

The ICS receives fused B+ from a fuse in the Power Distribution Center (PDC) and ground through a connection at the floor pan ground stud near the front center the floor console.

The individual controls located in the ICS cannot be adjusted or repaired. If any control on the ICS or control indicator lamp is inoperative or damaged, the entire ICS must be replaced. Refer to MODULE, INTEGRATED CENTER STACK (ICSM), REMOVAL .

The individual controls located in the radio touch screen cannot be adjusted or repaired. If a radio touch screen control or control indicator lamp is inoperative or damaged, the entire radio must be replaced. Refer to RADIO, REMOVAL .

Prior to replacing an ICS, check for any Diagnostic Trouble Codes (DTCs) related to the affected system, and run any related calibration procedures to verify that the concern is not a calibration issue. Refer to STANDARD PROCEDURE .