Transmission Verification Test-8HP70

WARNING: This page is about a different variant/trim than selected.

Reinstall any removed components.
Reconnect any disconnected electrical connectors.
With the scan tool, erase TCM DTCs.
With the scan tool, erase ESM DTCs.
With the scan tool, erase ABS DTCs.
With the scan tool, erase PCM DTCs.
CAUTION:
Apply the parking brake.
With the scan tool, display the Transmission Temperature.
Start the engine and allow the transmission fluid temperature to reach 43° C (110° F).
Check for Transmission fluid leaks.
If internal transmission components were repaired or replaced check the Transmission fluid level and adjust if necessary. Refer to STANDARD PROCEDURE - CHECK OIL LEVEL .
If any internal transmission repairs were performed or the Transmission Control Module (TCM) was replaced, perform the TCM ADAPTATION procedure. Refer to TRANSMISSION CONTROL MODULE (TCM) ADAPTATION .
Perform the ROAD TEST PROCEDURE
ROAD TEST PROCEDURE
1. Operate the vehicle in a manner that will allow 15-20 upshifts through all of the gears.
2. Allow these shifts to occur from 0 kPh (0 mph) to 72 kPh (45 mph) with a constant throttle opening of 20 to 25 degrees.
3. Operate the vehicle below 40 kPh (25 mph) and then perform a throttle kick-down maneuver to 1st gear. Do this several times from below 40 kPh (25 mph).
4. With the scan tool, read TCM DTCs.
Did any TCM DTCs set?

Yes
- Repair TCM DTCs. Refer to DTC INDEX .
No
- Test complete.