April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic Test

WARNING: This page is about a different variant/trim than selected.

CHECK FOR AN ACTIVE DTC
1. Turn ignition ON, engine NOT running.
2. Record the Environmental Data for this DTC.
3. With the scan tool, clear the DTC.
4. Using the Environmental Data recorded earlier, try to duplicate the conditions in which the DTC set. It may be necessary to test drive the vehicle.
5. With the scan tool, read ESM DTC's.
  Did the DTC reset?
  
  Yes
  - Using the schematics as a guide, check the ESM terminals for corrosion, damage or terminal push out. Pay particular attention to power and ground circuits. Check Service Information Tune-ups or Service Bulletins for possible causes that may apply. If no trouble is found, replace the ESM. Refer to SHIFTER, TRANSMISSION, REMOVAL .
  - Perform the TRANSMISSION VERIFICATION TEST. Refer to TRANSMISSION VERIFICATION TEST .
  No
  - Go To 2
INTERMITTENT WIRING AND CONNECTORS
1. The conditions necessary to set this DTC are not present at this time.
2. Using the schematics as a guide, inspect the wiring and connectors specific to this circuit.
3. Wiggle the wiring and connectors while checking for any possible open or shorted circuits.
4. Check for any Service Information Tune-ups or Technical Service Bulletins that may apply.
  Were any problems found?
  
  Yes
  - Repair as necessary.
  - Perform the TRANSMISSION VERIFICATION TEST. Refer to TRANSMISSION VERIFICATION TEST .
  No
  - Test complete.