Power Seat System Verification Test

PERFORM POWER SEAT SYSTEM VERIFICATION TEST 

1. Disconnect all jumper wires and reconnect all previously disconnected components and connectors.
2. Make sure that all accessories are turned off.
3. Make sure that the battery is fully charged.
4. Turn the ignition on.
5. Using a scan tool, record and erase Diagnostic Trouble Codes (DTCs) from all modules.
6. Operate the driver seat in all positions.
7. Turn the ignition off, wait 10 seconds, then turn the ignition on.
8. With the scan tool, read DTCs.

   Are the original condition(s) still present or is there DTCs present in any module(s)?

   Yes 

   • The repair is not complete. Perform the appropriate diagnostic procedure for the DTC or symptom that is still present. Refer to DIAGNOSTIC CODE INDEX 

   No 

   • The repair is complete.