Module, Adaptive Cruise Control (Acc): Installation: Module
NOTE:
The molded plastic ball socket clips in the ACC sensor mounting bracket MUST be removed, discarded and replaced with new ball socket clips any time the sensor is removed from the bracket.
- Install three new molded plastic ball socket clips into the Adaptive Cruise Control (ACC) sensor mounting bracket (2) located below the center of the front bumper support bar. The clips are installed from the back side of the bracket by rotating them clockwise.
- Position the ACC sensor to the mounting bracket.
- Align the one fixed and the two adjustable ball studs of the sensor with the three plastic ball socket clips in the bracket.
- Using hand pressure, press firmly and evenly on the face of the sensor until each of the ball studs snaps into the ball socket clips.
- Connect the wire harness connector (2) to the ACC sensor.
- Align the ACC sensor mounting bracket to the front bumper bracket reference marks.
- Install and tighten the fasteners (1) securely.
- If equipped, snap the sensor bezel (1) over the face of the ACC sensor (2).
- Remove the support and lower the vehicle.
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.
- Check the ACC sensor vertical alignment. Refer to MODULE, ADAPTIVE CRUISE CONTROL (ACC), MODULE PROGRAMMING .
- Install the bezel (1) to the center opening of the grille insert in the lower air intake opening of the front fascia (2).
- Use a diagnostic scan tool and the appropriate diagnostic information to perform the horizontal sensor alignment procedure. Refer to MODULE, ADAPTIVE CRUISE CONTROL (ACC), MODULE PROGRAMMING .