Module, Blind Spot (BSM): Removal

NOTE:

The sensor brackets are bonded to and integral to the back side of the rear bumper fascia.

Disconnect and isolate the negative cable from the battery.
Remove the bumper fascia from the rear of the vehicle. Refer to FASCIA, REAR, REMOVAL .

Courtesy of CHRYSLER GROUP, LLC
From the back of the fascia, disconnect the wire harness connector (2) from the blind spot monitor sensor connector receptacle.
Remove the screw (1) which is on the rearward boss location.

Courtesy of CHRYSLER GROUP, LLC
Carefully pry the sensor bracket latch features away from the top and bottom latch tabs of the sensor (1) far enough to disengage the sensor from the bracket and remove the sensor.