Module, Memory, Seat (MSM): Removal
NOTE:
The scan tool standardization process must be performed on the Memory Seat Module (MSM) any time a new MSM is installed or the existing MSM is reflashed.
NOTE:
Depending on how equipped, more memory seat module electrical connectors may be present than shown in the illustration.
- Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
- Remove the fasteners that secure the driver seat to the body and tip the seat rearward to gain access to the underneath of the seat. Refer to SEAT, FRONT, REMOVAL .
- Disconnect the electrical connectors (3 and 6) from the Memory Seat Module (MSM) (1).
- Disengage the two rear MSM retaining tabs (5 and 7) from the bracket (8) by carefully pushing the rear of the MSM upward.
- Disengage the two front MSM retaining tabs (2 and 4) from the bracket by pulling the MSM rearward.
- Remove the MSM from underneath the driver seat.