Module, Blind Spot (BSM): Installation

Courtesy of CHRYSLER GROUP, LLC

Slide the blind spot module into the mounting bracket, on the rear bumper fascia.
NOTE:
Make sure to install the blind spot module in the direction shown. Otherwise, improper blind spot functionality and/or blind spot module faults may occur.

NOTE:
The blind spot module must be slid into bracket, do not attempt to snap the module into bracket.
Insert tabs, opposite the connector, and index the left side into the clips with pressure on the fastener. Apply pressure over the fasteners on the right side to seat in the other clips.

Courtesy of CHRYSLER GROUP, LLC
Insert the screw into the right rearward blind spot module boss (1).
Connect the rear bumper fascia wiring harness connector (2) to the blind spot module.
Install the rear bumper fascia onto the vehicle. Refer to FASCIA, REAR, INSTALLATION .
Connect the negative cable to the battery.
With the scan tool, verify no DTCs are present.
Test drive vehicle and verify the proper function of blind spot functions (if functioning improperly verify blind spot is active via radio).
Verify no DTCs are present, after the test drive.