Module, Blind Spot (BSM): Removal

NOTE:

The blind spot module mounting brackets are bonded to, and integral to, the back side of the rear bumper fascia.

Disconnect and isolate the negative battery cable.
Remove the rear bumper fascia from the vehicle. Refer to FASCIA, REAR, REMOVAL .

Courtesy of CHRYSLER GROUP, LLC
From the back of the rear fascia, disconnect the wiring harness connector (2) from the blind spot module.
Remove the screw (1) from the right rearward blind spot module boss location.
Slide the blind spot module (1) out of the mounting bracket.