LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2020 >> ProMaster 2500 >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Electronic Control Modules (Service Information)) >> Module, Vehicle System Interface (VSIM) >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Module, Vehicle System Interface (VSIM): Installation

WARNING: This page is about a different car, the 2020 Dodge Charger. However, it is still accessible from the selected car via links, so may be relevant.
GC0170780Courtesy of CHRYSLER GROUP, LLC
  1. Position the Vehicle System Interface Module (VSIM) (1) to the bracket with the upper guide (2) aligned with the VSIM bracket opening.
    GC0170627Courtesy of CHRYSLER GROUP, LLC
  2. Engage the upper VSIM guide to the slot opening (1) located at the top of the VSIM bracket.
    GC0170633Courtesy of CHRYSLER GROUP, LLC
  3. Seat the lower portion of the VSIM to the bracket and press inward until the lower guide (1) snaps into position.
    GC0170605Courtesy of CHRYSLER GROUP, LLC
  4. Connect the wire harness connectors (1) to the VSIM.
  5. Install the instrument panel end cap. Refer to CAP, INSTRUMENT PANEL END, INSTALLATION .
  6. Install the steering column opening cover. Refer to COVER, STEERING COLUMN OPENING, INSTALLATION .
  7. Connect the negative cable to the battery. If equipped with an Intelligent Battery Sensor (IBS), reconnect the IBS connector.
scientia non olet · About LEMON Manuals