LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2020 >> ProMaster 3500 Van Cargo Extended >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (Electronic Control Modules (Service Information)) >> Module, Vehicle System Interface (VSIM) >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Module, Vehicle System Interface (VSIM): Removal

WARNING: This page is about a different car, the 2020 Dodge Charger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the instrument panel end cap. Refer to CAP, INSTRUMENT PANEL END, REMOVAL .
  2. Remove the steering column opening cover. Refer to COVER, STEERING COLUMN OPENING, REMOVAL .
  3. Disconnect and isolate the negative cable from the battery. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector before disconnecting the negative cable from the battery.
    GC0170605Courtesy of CHRYSLER GROUP, LLC
  4. Disconnect the wire harness connectors (1) from the Vehicle System Interface Module (VSIM).
    GC0170633Courtesy of CHRYSLER GROUP, LLC
  5. Depress the tab (1) at the bottom of the VSIM. This will release the lower portion of the VSIM from the VSIM bracket.
  6. Pull the VSIM down and at an angle to release the upper guide tab from the VSIM bracket.
  7. Remove the VSIM from the vehicle.
scientia non olet · About LEMON Manuals