Module, Body Control (BCM): Installation
WARNING: This page is about a different car, the 2021 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
- Slide the BCM (4) upper tab(s) to the upper mounting stud(s) and install the lower tabs to the lower mounting studs.
- Install and securely tighten the lower mounting fasteners (3).
- Install and securely tighten the lower mounting fastener(s) (1).
- Connect the BCM wire harness connectors (2).
- Install the glove box assembly. Refer to GLOVE BOX, INSTRUMENT PANEL, INSTALLATION .
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
NOTE:
Program the BCM in accordance with the module replacement and programming guide. Refer to STANDARD PROCEDURE .