Module, Park Assist (PAM): Installation
WARNING: This page is about a different car, the 2021 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
- Position the Park Assist Module (PAM) (1) to the right quarter inner panel above and behind the right rear wheel house.
- Install the retainers (2) that secure the PAM to the right quarter inner panel.
- Connect the wire harness connectors (3) to the PAM.
- Install the trim onto the right quarter inner panel. Refer to PANEL, TRUNK TRIM, REAR, INSTALLATION .
- Connect the negative cable to the battery. If equipped with an Intelligent Battery Sensor (IBS), reconnect the IBS connector.