Module, Radio Frequency (RF Hub): Installation
WARNING: This page is about a different car, the 2021 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
- Position into place and install the Remote Frequency Hub (RF-Hub) and retainers (1).
- Connect the wire harness connectors (2).
- If equipped, connect the remote start antenna (3).
- Install the rear shelf cover. Refer to PANEL, REAR SHELF, INSTALLATION .
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
NOTE:
Program the RF-Hub in accordance with the module replacement and programming guide. Refer to STANDARD PROCEDURE .