Diagnostic Test
- CHECK FOR ACTIVE DTCS
- With the scan tool, record and erase the DTCs.
- Cycle the ignition off, wait 10 seconds, then cycle the ignition on.
- Operate the power liftgate several times if possible.
- With the scan tool, read the Active DTCs.
Does the scan tool display; B1968-00-POWER LIFTGATE OPEN DIRECTION - EXCESSIVE TIME?
Yes
- Go To 2
No
- Using the wiring diagram/schematic as a guide, inspect the wiring and connectors for an intermittent condition. Operate the liftgate several times and check for any binding conditions.
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
- CHECK FOR A BINDING LIFTGATE
- Examine the liftgate for proper alignment, worn or binding hinges, weak liftgate prop assembly, or loose/hard weatherstrip or anything that would cause an obstruction to proper operation. Check for the possibility of the liftgate having been overloaded due to ice or heavy snow.
- Raise the liftgate and check the struts for proper operation.
- If necessary manually operate the liftgate of a known good vehicle and notice the effort needed.
- Compare the effort needed on the disabled vehicle.
Were there any mechanical problems found?
Yes
- Refer to Standard Procedures according to the Service Information. Refer to STANDARD PROCEDURE - LIFTGATE OPERATION .
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
No
- Go To 3
- OPERATE THE POWER LIFTGATE DRIVE UNIT
- Re-connect the Power Liftgate Module C1 connector.
- Operate the Power Liftgate in both directions if possible.
Does the motor start to lift the liftgate but is very slow and labors extensively?
Yes
- Replace the Power Liftgate Drive Unit in accordance with the Service Information. Refer to DRIVE UNIT, POWER, REMOVAL .
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
No
- Replace the Power Liftgate Module in accordance with the Service Information. Refer to MODULE, POWER LIFTGATE (PLGM), REMOVAL .
- Test complete. Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .