Module, Integrated Center Stack (ICSM): Installation

Courtesy of CHRYSLER GROUP, LLC

1. Position the Integrated Center Stack (ICS) (1) to the instrument panel. Connect the wire harness connector.
2. Install the ICS (1) into the instrument panel, hand tap to fully set the retaining clips.

   Courtesy of CHRYSLER GROUP, LLC

3. Install the ICS fasteners (1) and tighten securely.
4. Install the passenger side Instrument Panel Center Trim Panel. Refer to PANEL, INSTRUMENT PANEL TRIM, CENTER, INSTALLATION .
5. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.