Module, Radio Frequency (RF Hub): Installation
NOTE:
Replace and Program the module(s) per the RF-Hub, BCM, PCM FOBIK and ELV Replacement and Programming Order Guide. Refer to RF-HUB, PCM AND BCM REPLACEMENT AND PROGRAMMING ORDER GUIDE .
- Position the Radio Frequency (RF Hub) Module to the vehicle, install and securely tighten the fasteners (2).
- If equipped, connect the remote start antenna wiring harness connector.
- Connect the RF-Hub Module wiring harness connectors (1).
- Install the left rear cargo interior trim panel. Refer to PANEL, QUARTER TRIM, INSTALLATION .
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
NOTE:
Program the RF-Hub Module. Refer to MODULE, RADIO FREQUENCY (RF HUB), MODULE PROGRAMMING .