Module, Electronic Limited Slip Differential (ELSD): Installation

Courtesy of CHRYSLER GROUP, LLC

1. Place the Electronic Limited Slip Differential (ELSD) module onto the mounting bracket, making sure the bottom slides into the mounting bracket tabs (1).

   Courtesy of CHRYSLER GROUP, LLC

2. Install the ELSD module to mounting bracket bolt (1).
3. Connect the wire harness connectors (2) to the ELSD module.
4. Install the left quarter panel trim. Refer to PANEL, QUARTER TRIM, INSTALLATION .
5. Connect the negative battery cable. Refer to CABLES, BATTERY, INSTALLATION .
6. Perform the Electronic Limited Slip Differential (ELSD) verification test. Refer to ELSD VERIFICATION TEST .