Module, Memory Seat (MSM): Installation
NOTE:
Depending on vehicle options, the amount of MSM wiring harness connectors may differ.
- Position the Memory Seat Module (MSM) (1) onto the driver seat and engage the front MSM retaining tabs (2 and 4) into the bracket (8).CAUTION:
Properly align the rear Memory Seat Module (MSM) retaining tabs to the bracket, prior to engagement. Failure to follow these instructions may result damage to the MSM rear retaining tabs.
- Align the rear MSM retaining tabs (5 and 7) to the bracket, carefully pull downward on the MSM and engage the retaining tabs, making sure the retaining tabs are fully engaged.
- Connect the MSM wiring harness connectors (3 and 6).
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.NOTE:
If a new MSM is installed, the MSM learned parameters must be cleared and the Power Seat System Verification Test must be performed.
- Using a scan tool, under the Memory Seat Module Miscellaneous Functions tab, perform the Clear All MSM Learned Parameters.
- Perform the Power Seat System Verification Test. Refer to POWER SEAT SYSTEM VERIFICATION TEST .