With Display Screen Module

REMOVAL 

1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
2. Remove the center trim bezel from the instrument panel. Refer to BEZEL, INSTRUMENT PANEL, APPLIQUE, REMOVAL .
   CAUTION:

   Pulling the antenna cable straight out of the radio without pulling on the locking antenna connector could damage the cable or radio.

   Courtesy of CHRYSLER GROUP, LLC

3. Remove the fasteners (1) securing the Radio Receiver Module (RRM) bracket (2) to the instrument panel.

   Courtesy of CHRYSLER GROUP, LLC

4. Pull the lower part of the RRM and bracket (1) out and down far enough to access the back of the RRM.
5. Disconnect the electrical connector, antennas, and if equipped, the USB connector.
6. Remove the RRM from the instrument panel.