LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2021 >> Durango SXT Plus, AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Electronic Control Modules (Service Information) >> Module, Integrated Center Stack (ICSM) >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Module, Integrated Center Stack (ICSM): Removal

WARNING:

Disable the airbag system before attempting any steering wheel, steering column or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the passenger side Instrument Panel Center Trim. Refer to PANEL, INSTRUMENT PANEL TRIM, CENTER, REMOVAL .
    GC0200426Courtesy of CHRYSLER GROUP, LLC
  3. Remove the fasteners (1) that secure the Integrated Center Stack (ICS) (2) to the instrument panel.
    GC0200391Courtesy of CHRYSLER GROUP, LLC
  4. Using a trim stick or equivalent release the ICS (1) from the instrument panel.
  5. Disconnect the wire harness connector and remove the ICS (1) from the vehicle.
scientia non olet · About LEMON Manuals