LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2021 >> Durango SXT Plus, AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Electronic Control Modules (Service Information) >> Module, Security Gateway (SGW) >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Module, Security Gateway (SGW): Removal

NOTE:

If a new Electronic Control Unit (ECU) is being installed, use the scan tool and perform the Flash Programming Procedure (if available). 

  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove passenger side cowl panel. Refer to PANEL, COWL TRIM, SIDE, REMOVAL .
    GC0145521Courtesy of CHRYSLER GROUP, LLC
  3. Remove the fasteners, passenger silencer panel (1), and disconnect the wiring harness connector.
    GC0180911Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    The Security Gateway (SGW) Module is mounted to the Heating Venting and Air Conditioning (HVAC) case on the passenger side.

  4. Remove the bracket bolts (2) and disconnect the SGW Module wiring harness connectors (1).
    GC0180930Courtesy of CHRYSLER GROUP, LLC
  5. Remove the screws (1) securing the SGW Module to the bracket.
  6. Remove the SGW Module from the vehicle.
scientia non olet · About LEMON Manuals