Module, Light Rain Sensor: Removal
- Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
- Remove the trim cover from the inside rear view mirror mounting bracket. Refer to REMOVAL .
- Disconnect the Light Rain Sensor Module (LRSM) wiring harness connector (1) from the LRSM (2).
- Depress one side of the spring steel retaining strap on the LRSM towards the windshield while lightly prying the end of the strap closest to the glass away from the tab of the mounting bracket (3) on the windshield. Now rotate the loose side of the LRSM away from the glass far enough to disengage the other side of the strap from the mounting bracket tabs.
- Remove the LRSM from the mounting bracket.
- If the LRSM will be reinstalled, the silicone gelatin (SilGel) adhesive membrane pad MUST be removed, discarded and replaced with a new unit as described in: Standard Procedure - Silicone Gelatin Pad Replacement. Refer to MODULE, LIGHT RAIN SENSOR, STANDARD PROCEDURE .