All Windows Inoperative
- Check the circuit breaker. If OK, go to Step 2. If not OK, replace the inoperative circuit breaker.
- Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable. Remove the window/lock switch from the driver side front door trim panel. Disconnect the wire harness connector.
- Check for continuity between the ground circuit cavity of the Driver Door Module (DDM) wire harness connector and a good ground. If OK, go to Step 4. If not OK, repair the circuit to ground as required.
- Connect the battery negative cable. Set the ignition to the ON position. Check for battery voltage at the fused ignition output (run) circuit cavity of the window/lock switch wire harness connector. If OK. Refer to SWITCH, LOCK, DIAGNOSIS AND TESTING . If not OK, repair the circuit as required.