Diagnostic Test
WARNING: This page is about a different car, the 2021 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
CHECK IF THE DTC IS ACTIVE
- Turn the ignition off and remove the key from the ignition.
- Lock and close all doors to allow the VTSS to go from pre-arm to armed status and wait one minute.
- Disarm the VTSS.
- With the scan tool, read ITM DTCs.
Does the scan tool display this DTC as active?
Yes
- Replace the Intrusion Transceiver Module in accordance with the Service Information. Refer to MODULE, INTRUSION, REMOVAL .
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
No
- The condition or conditions that originally set this DTC are not present at this time. Using the appropriate SYSTEM WIRING DIAGRAMS as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .