Diagnostic Test
CHECK FOR AN ACTIVE DIAGNOSTIC TROUBLE CODE (DTC)
NOTE:
Diagnose any CAN Bus DTCs that may be set in other modules before proceeding with this diagnostic procedure.
- Turn the ignition on.
- With the scan tool, read active DTCs.
Dose the scan tool display this DTC as active?
Yes
- If no other CAN Bus DTCs are set in other modules and the SCCM is the only one reporting this DTC, replace the SCCM in accordance with the Service Information. Refer to MODULE, STEERING COLUMN CONTROL (SCCM), REMOVAL .
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
No
- Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the appropriate SYSTEM WIRING DIAGRAMS as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
- Perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .