Diagnostic Test
- VERIFY DTC IS ACTIVE NOTE:
Make sure the battery voltage is between 10 and 16 volts before proceeding.
- With the scan tool, read active DTCs.
Is this DTC active?
Yes
- Go To 2
No
- Refer to STORED LOST COMMUNICATION DTCS and perform the STORED LOST COMMUNICATION DTCS diagnostic procedure.
- With the scan tool, read active DTCs.
- CHECK FOR ANY OF THE FOLLOWING ACTIVE DTCS
- With the scan tool, read all active DTCs from all modules.NOTE:
Check for BCM configuration, CAN C hardware electrical, VIN Missing/Mismatch, battery or ignition related DTCs.
Does the scan tool display any active DTCs to the conditions listed above?
Yes
- Go to and perform the appropriate diagnostic procedure.
No
- Go To 3
- With the scan tool, read all active DTCs from all modules.
- VERIFY THE ABS IS ACTIVE ON THE BUS
- Turn the ignition on.
- With the scan tool, verify the ABS is active on the bus.
Is the ABS active on the bus?
Yes
- Go To 4
No
- Refer to DIAGNOSIS AND TESTING and perform the NO RESPONSE FROM ABS diagnostic procedure.
- CHECK FOR ADDITIONAL COMMUNICATION RELATED DTCS
- With the scan tool, read all the DTCs.
Is there more than one module with active DTCs "Logged Against" the ABS?
Yes
- Replace/update the ABS module in accordance with the Service Information. Refer to MODULE, ANTI-LOCK BRAKE SYSTEM (ABS), REMOVAL .
- Perform the ABS VERIFICATION TEST. Refer to ABS VERIFICATION TEST .
No
- Go To 5
- With the scan tool, read all the DTCs.
- CLEAR DTC IN MODULE SETTING FAULT
- With the scan tool, select the module setting the DTC against the ABS.
- Clear active DTCs.
Is this DTC still active?
Yes
- Replace/update the module that set this DTC in accordance with the Service Information.
- Perform the appropriate verification test for the module being replaced. If there is no verification test for the associated module perform the BODY VERIFICATION TEST. Refer to BODY VERIFICATION TEST .
No
- Test Complete.