Module, Security Gateway (SGW): Installation

WARNING: This page is about a different car, the 2022 RAM ProMaster 3500, 2022 RAM ProMaster 2500, and 2022 RAM ProMaster 1500. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

If a NEW Security Gateway (SGW) module is being installed, use the diagnostic scan tool to flash the module. Failure to flash the module will leave the SGW module in a locked mode preventing SGW module operation.

Courtesy of CHRYSLER GROUP, LLC

Position the SGW module (3) to the glove box assembly (4).
Install the SGW module fasteners (1) and tighten the fasteners securely.
Install the glove box assembly. Refer to GLOVE BOX, INSTRUMENT PANEL, INSTALLATION .
Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
If a NEW SGW module is installed, use the diagnostic scan tool to flash the SGW module.