Module, Transmission Control (TCM): Installation

Courtesy of CHRYSLER GROUP, LLC

1. Slide the Transmission Control Module (TCM) into the mounting bracket.
2. Close the lower TCM bracket tab (1) by snapping the tab (2) onto the bracket.

   Courtesy of CHRYSLER GROUP, LLC

3. Close the upper TCM bracket tab (1) by snapping the tab (2) onto the bracket.

   Courtesy of CHRYSLER GROUP, LLC

4. Install the TCM bracket screws (2).
5. Connect the wire harness connectors (1, 3) to the TCM.

   Courtesy of CHRYSLER GROUP, LLC

6. Position the left kick panel (3) into place.
7. Install the kick panel fasteners (2, 4) and tighten securely.
8. Install the kick panel nut (1).
9. If necessary, perform the verification test procedure.