Module, Anti-Lock Brake System (Abs): Installation

WARNING: This page is about a different car, the 2020 Dodge Challenger. However, it is still accessible from the selected car via links, so may be relevant.

Clean any debris off the mating surfaces of the HCU and ABM.
NOTE:
When installing a new ABM seal, do not use any type of lubricant.

Courtesy of CHRYSLER GROUP, LLC
If the seal (1) on the ABM (2) are not new, replace them. The ABM seal must be new to keep out moisture and debris; do not reuse the ABM seal .

Courtesy of CHRYSLER GROUP, LLC
Align components and install the ABM (1) on the HCU (2).

Courtesy of CHRYSLER GROUP, LLC
Install the three ABM to HCU mounting screws (3). Tighten to the proper specification. Refer to TORQUE SPECIFICATIONS - BASE BRAKES or TORQUE SPECIFICATIONS - ABS BRAKES .
Install the two ICU to bracket bolts and tighten to the proper specification. Refer to TORQUE SPECIFICATIONS - BASE BRAKES or TORQUE SPECIFICATIONS - ABS BRAKES . .
Install the ICU in the vehicle. Refer to INTEGRATED CONTROL UNIT (ICU), INSTALLATION .