Sunroof Initialization And Obstacle Detection Calibration

Sunroof initialization and obstacle detection calibration is a process to teach the sunroof motor where to stop for the correct open, close and vent positions and calibrate the obstacle detection system.

There are two procedures for initialization and obstacle detection calibration. Select the appropriate procedure for the situations described. 

Procedure 1: Initialization and Obstacle Detection Calibration  - Procedure 1 must be followed when a new service replacement motor is installed.

1. Set the vehicle ignition to Accessory or start engine.
2. Press and hold the sunroof VENT switch. Sunroof motor will activate and drive into the vent hard stop, stall and stop (an audible click will be heard from the motor).
3. Release the sunroof VENT switch after all motion has stopped; initialization is complete.
4. Press and hold the sunroof CLOSE switch to cycle glass from vent to closed position.
5. Press and hold the sunroof OPEN switch to cycle glass from closed to open position.
6. Press and hold the sunroof CLOSE switch to cycle glass from open to closed position.
7. Press and hold the sunroof VENT switch to cycle glass from closed to vent position.
8. Press and hold the sunroof CLOSE switch to cycle glass from vent to closed position.
9. Repeat steps 5-8 until a total of five complete open, close, vent cycles have been completed to calibrate the obstacle detection system.
10. Confirm sunroof glass express operation (press and release switch) is functional for open, vent and close operations.

Procedure 2: Re-initialization and Obstacle Detection Calibration 

- Procedure 2 must be followed if any of the following is true:

• Original existing motor has been removed and re-installed on the sunroof module.
• Glass Assembly has been replaced.
• Sunroof glass closed position setting incorrect
• Sunroof glass is auto-reversing during express close operation with no obstruction blocking sunroof.
• Express operation (one touch) is not functioning.
• Sunroof Assembly or Glass Assembly have been removed and reinstalled in vehicle.

1. Set the vehicle ignition to Accessory or start engine.
2. Press and hold the sunroof VENT switch. Sunroof motor will activate and drive into the vent position and stop. Release the VENT switch.
3. Press and hold the VENT switch again, after 1 second the sunroof motor will activate again and drive into a hard stop in the vent position, stall and stop (an audible click will be heard from the motor).
4. Release the sunroof VENT switch after all motion has stopped; initialization is complete.
5. Press and hold the sunroof CLOSE switch to cycle glass from vent to closed position.
6. Press and hold the sunroof OPEN switch to cycle glass from closed to open position.
7. Press and hold the sunroof CLOSE switch to cycle glass from open to closed position.
8. Press and hold the sunroof VENT switch to cycle glass from closed to vent position.
9. Press and hold the sunroof CLOSE switch to cycle glass from vent to closed position.
10. Repeat steps 5-8 until a total of five complete open, close, vent cycles have been completed to calibrate the obstacle detection system.
11. Confirm sunroof glass express operation (press and release switch) is functional for open, vent and close operations.