Module, Power Sunroof (PSM): Removal
WARNING: This page is about a different car, the 2020 Dodge Challenger. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Do not attempt to move or reposition the sunroof glass panel or drive cables with the sunroof motor and module unit removed. Damage to the vehicle, to the sunroof or personal injuries may result.
WARNING:
The Sunroof Motor And Module Initialization procedure must be completed any time a sunroof motor and module unit is replaced with a new component. Failure to perform this procedure may result in damage to the vehicle, to the sunroof or in serious or fatal injuries.
- Disconnect and isolate the battery negative cable.
- Lower the back of the headliner (1) to gain access to the sunroof motor (4). Refer to HEADLINER, REMOVAL .
- Remove the three screws (2) that secure the motor to the sunroof frame.
- Lower the motor far enough to access and disconnect the sunroof wire harness connector from the motor connector receptacle (3).
- Remove the sunroof motor from the vehicle.