Module, Body Control (BCM): Installation

Courtesy of CHRYSLER GROUP, LLC

Slide the BCM (4) upper tab(s) to the upper mounting stud(s) and install the lower tabs to the lower mounting studs.
Install and securely tighten the lower mounting fasteners (3).
Install and securely tighten the lower mounting fastener(s) (1).
Connect the BCM wire harness connectors (2).
Install the glove box assembly. Refer to GLOVE BOX, INSTRUMENT PANEL, INSTALLATION .
Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.

NOTE:

Program the BCM in accordance with the module replacement and programming guide. Refer to IMMOBILIZER COMPONENTS AND REPLACEMENT GUIDE .