Module, Powertrain Control (Pcm): Installation

Courtesy of CHRYSLER GROUP, LLC

If removed, position the Powertrain Control Module (PCM) mounting bracket (1) onto the PCM (4), install the fasteners (2) and tighten to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
If removed, install the NVH rubber bumper (3) onto the PCM.

Courtesy of CHRYSLER GROUP, LLC

NOTE:
Prior to reconnecting the wire harness connectors to the PCM, check the pins in the PCM for misalignment and/or damage. Repair as necessary.
Position the PCM (3) into the vehicle.
Connect the PCM wire harness connectors (2).
Position the PCM bracket to the cross support, install the fastener (1) and tighten to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .

Courtesy of CHRYSLER GROUP, LLC
Position the front cowl top panel (1) to the right rear corner of the engine compartment.
Install the fasteners (2) that secure the front cowl top panel.
Connect the negative battery cable.
NOTE:
If a new PCM is installed, it must be programed with the original Vehicle Identification Number (VIN) and mileage. If this is not done, a Diagnostic Trouble Code (DTC) may set.

NOTE:
If a new PCM is installed. Refer to MODULE, POWERTRAIN CONTROL (PCM), MODULE PROGRAMMING .
If a new PCM is being installed, use a scan tool and program the new PCM with the original VIN and vehicle mileage.