Module, Integrated Center Stack (ICSM): Installation

Courtesy of CHRYSLER GROUP, LLC

Position the Integrated Center Stack (ICS) module (2) to the instrument panel and connect the wire harness connectors.
Install the ICS module (2) to the instrument panel.
Install the fasteners (1) that secure the ICS and tighten securely.
Install the Display Screen Module (DSM). Refer to MODULE, DISPLAY SCREEN (DSM), INSTALLATION .
Install the instrument panel trim panel. Refer to PANEL, INSTRUMENT PANEL TRIM, INSTALLATION .
Initiate the Actuator Calibration function using a scan tool. Refer to HVAC PRE-DIAGNOSTIC TROUBLESHOOTING PROCEDURE .

NOTE:

If this Electronic Control Unit (ECU) is being replaced with a new unit, a diagnostic scan tool MUST be used to determine if alignment of the PROXI configuration data into the new ECU is needed. If PROXI alignment is needed, follow the routine outlined in the diagnostic scan tool for PROXI Configuration Alignment under the Body Control Module (BCM) Miscellaneous Functions menu.