LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2023 >> ProMaster 2500 >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Drivers Assistance Systems - ADAS >> Electronic Control Modules (Service Information) >> Module, Powertrain Control (Pcm) >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Module, Powertrain Control (Pcm): Installation

GC0160470Courtesy of CHRYSLER GROUP, LLC
  1. If removed install the PCM bracket (2) and tighten the fasteners (3) to 18 N.m (13 ft. lbs.).
  2. Position the Powertrain Control Module (PCM) (1) to the PCM bracket (2) and tighten the three nuts (4) to 8 N.m (71 in. lbs.).
  3. Connect and lock the wire harness connectors (1) to the PCM.
  4. Install the protective cover over the PCM electrical connectors.
  5. Connect the negative battery cable.
    NOTE:

    If a new PCM is installed, it must be programed with the original Vehicle Identification Number (VIN) and mileage. If this is not done, a Diagnostic Trouble Code (DTC) may set.

    NOTE:

    If a new PCM is installed. Refer to STANDARD PROCEDURE .

  6. If a new PCM is being installed, use a scan tool to program the new PCM with the original VIN and vehicle mileage.
scientia non olet · About LEMON Manuals