LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2023 >> ProMaster 2500 >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> Restraints (Service Information) >> CLOCKSPRING >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Restraints (Service Information): CLOCKSPRING: Removal

WARNING:

To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.

CAUTION:

Always turn the steering wheel until the front wheels are in the straight-ahead position. Then, prior to disconnecting the steering column from the steering gear, lock the steering wheel to the steering column. If clockspring centering has been compromised for ANY reason, the entire Steering Column Control Module (SCCM) and clockspring unit MUST be replaced with a new unit.

  1. Place the front wheels in the straight ahead position and inhibit the steering column shaft from rotation.
  2. Disconnect and isolate the negative battery cable.
  3. Remove the steering wheel from the upper steering column. Refer to WHEEL, STEERING, REMOVAL .
  4. If the removed clockspring and stalk unit is to be reused, be certain that the spring-activated clockspring locking ring has extended upward following steering wheel removal to lock the clockspring rotor to the clockspring case and maintain clockspring centering until the steering wheel is reinstalled on the steering column. Do not manually compress the clockspring locking ring while the stalk unit is removed from the steering column as this may result in the loss of clockspring centering.  Optionally, secure the clockspring rotor to the clockspring case with adhesive tape. If clockspring centering is not maintained, the entire clockspring and stalk unit must be replaced with a new unit before the steering wheel is installed.
  5. Move the steering column to the fully lowered (down) position.
  6. Remove the upper shroud from the steering column. Refer to COLUMN, REMOVAL .
  7. Remove the lower shroud from the steering column. Refer to COLUMN, REMOVAL .
    GC0204100Courtesy of CHRYSLER GROUP, LLC
  8. Disconnect the clockspring wire harness connectors (2) from the clockspring.
  9. Loosen the band clamp screw (1).
  10. Remove the clockspring.
scientia non olet · About LEMON Manuals