Module, Park Assist (PAM): Installation
- Position the Park Assist Module (PAM) (4) to the right lower inner D-pillar (2).
- Engage the mounting tabs on the bottom of the PAM into the two slots in the inner D-pillar.
- Install the fastener (1) that secures the mounting tab at the top of the PAM to the inner D-pillar.
- Connect the wire harness connectors (3) to the PAM connector receptacles. Vehicles with the front park assist option will have an additional connection to the PAM at this location, which must also be connected.
- Install the trim onto the right quarter inner panel. Refer to PANEL, QUARTER TRIM, INSTALLATION .
- Connect the negative cable to the battery.