LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Dodge and Ram >> 2024 >> Durango R/T, AWD >> Repair and Diagnosis >> Steering >> Steering Control Systems >> (Electronic Power Steering (EPS) Module - Electrical Diagnostics) >> DTC Troubleshooting >> C15DB-00 EPS Disabled >> Diagnostic Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic Test

  1. CHECK FOR AN ACTIVE DTC 
    NOTE:

    If DTC C15C1-00 or C2217-00 are present, refer to the diagnostics for these DTCs before continuing with this diagnostic procedure.

    NOTE:

    This DTC must be active for the results of this test to be valid.

    NOTE:

    Make sure the ambient temperature of the vehicle is above -40°C (-40°F)

    CAUTION:

    Do NOT disconnect the Torque Sensor (Grey) harness connector on the electric power steering gear, as permanent damage can occur to the Electric Power Steering (EPS) Module.

    1. Turn the ignition on.
    2. With the scan tool, read and record the Environmental Data to help identify the conditions in which the DTC was set.
    3. With the scan tool, read DTCs and record on vehicle work order.
    4. With the scan tool, erase DTCs.
    5. Test drive the vehicle at speeds above 30 km/h (19 mph).
    6. Park the vehicle.
    7. With the scan tool, read EPS DTCs.

      Is the DTC active?

      Yes 

      • Go To  2

      No 

      • The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring harness and electrical connectors.
      • Perform the EPS VERIFICATION TEST. Refer to: EPS VERIFICATION TEST  .
  2. CHECK RELATED HARNESS CONNECTIONS 
    NOTE:

    Do not disconnect the Torque Sensor (Grey) harness connector and make sure it is connected properly.

    1. Disconnect the EPS Module harness connectors.
    2. Disconnect all related in-line harness connections (if equipped).
    3. Disconnect the related component harness connectors.
    4. Inspect harness connectors, component connectors, and all male and female terminals for the following conditions:
      • Proper connector installation.
      • Damaged connector locks.
      • Corrosion.
      • Other signs of water intrusion.
      • Weather seal damage (if equipped).
      • Bent terminals.
      • Overheating due to a poor connection (terminal may be discolored due to excessive current draw).
      • Terminals that have been pushed back into the connector cavity.
      • Perform a terminal drag test on each connector terminal to verify proper terminal tension.

      Repair any conditions that are found.

    5. Connect the EPS Module harness connectors. Be certain that the harness connectors are fully seated and the connector locks are fully engaged.
    6. Connect all in-line harness connectors (if equipped). Be certain that all connectors are fully seated and the connector locks are fully engaged.
    7. Connect the related component harness connectors. Be certain that all connectors are fully seated and the connector locks are fully engaged.
    8. With the scan tool, erase DTCs.
    9. Using the recorded Event and Environmental Data, along with the When Monitored and Set Conditions above, operate the vehicle in the conditions that set the DTC.
    10. With the scan tool, read EPS Module DTCs.

      Did the DTC return?

      Yes 

      • Replace the Electric Power Steering (EPS) Module in accordance with service information.
      • Perform the EPS VERIFICATION TEST. Refer to: EPS VERIFICATION TEST  .

      No 

scientia non olet · About LEMON Manuals